ZyXEL Communications ZyXEL Dimension GS-4012F - Manual (Page 202)

GS-4012F/4024 User’s Guide
Chapter 32 Maintenance 201
3 Choose a location to save the file on your computer from the Save in drop-down list box
and type a descriptive name for it in the File name list box. Click Save to save the
configuration file to your computer.
32.5 Load Factory Defaults
Follow the steps below to reset the switch back to the factory defaults.
1 In the Maintenance screen, click the Click Here button next to Load Factory Defaults
to clear all switch configuration information you configured and return to the factory
defaults. The following message appears.
Figure 119 Load Factory Default: Conformation
2 Click OK to display the screen shown next.
Figure 120 Load Factory Default: Start
3 Click OK to begin resetting all switch configurations to the factory defaults and then wait
for the switch to restart. This takes up to two minutes. If you want to access the switch
web configurator again, you may need to change the IP address of your computer to be in
the same subnet as that of the default switch IP address (192.168.1.1).
32.6 Reboot System
Reboot System allows you to restart the switch without physically turning the power off.
Follow the steps below to reboot the switch.
1 In the Maintenance screen, click the Click Here button next to Reboot System to
display the next screen.
Figure 121 Reboot System: Confirmation
2 Click OK to display the screen shown next.