ZyXEL Communications ZyXEL Dimension GS-4012F - Manual (Page 261)

GS-4012F/4024 User’s Guide
260 Chapter 40 Introducing the Commands
40.9.4 interface port-channel Commands
The following table lists the interface port-channel commands in configuration mode.
Use these commands to configure the ports.
Table 96 interface port-channel Commands
COMMAND DESCRIPTION
interface
port-channel
Enables a port or a list of ports
for configuration.
bandwidth-limit Enables bandwidth control on
the port(s).
cir Sets the guaranteed bandwidth
allowed for incoming traffic on
the port(s).
egress Sets the maximum bandwidth
allowed for outgoing traffic on
the port(s).
ingress Sets the maximum bandwidth
allowed for incoming traffic on
the port(s).
pir Sets the maximum bandwidth
allowed for incoming traffic on
the port(s).
bpdu-control
|network>
Sets how Bridge Protocol Data
Units (BPDUs) are used in STP
port states.
broadcast-limit Enables broadcast storm
control limit on the switch.
diffserv Enables DiffServ on the port(s).
Sets how many broadcast
packets the interface receives
per second.
dlf-limit Enables the Destination Lookup
Failure (DLF) limit.
Sets the interface DLF limit in
packets per second (pps).
egress set
list>
Sets the outgoing traffic port list
for a port-based VLAN.
exit Exits from the interface port-
channel command mode.
flow-control Enables interface flow control.
Flow control regulates
transmissions to match the
bandwidth of the receiving port.
frame-type Choose to accept both tagged
and untagged incoming frames
or just tagged incoming frames
on a port.