ZyXEL Communications ZyXEL Dimension GS-4012F - Manual (Page 238)

GS-4012F/4024 User’s Guide
Chapter 40 Introducing the Commands 237
3 A login screen displays (refer to Section 40.3 on page 237 ).
40.3 The Login Screen
After you have successfully established a connection to the switch using a direct console
connection or Telnet, a login screen displays as shown below. For your first login, enter the
default administrator login username “admin” and password “1234”.
Figure 151 CLI: Login Screen
40.4 Command Syntax Conventions
The rules of the commands are listed next.
• The command keywords are in courier new font.
• The required fields in a command are enclosed in angle brackets <>, for instance, ping
means that you must specify an IP number for this command.
• The optional fields in a command are enclosed in square brackets [], for instance,
configure snmp-server [contact ] [location
]
means that the contact and location fields are optional.
• “Command” refers to a command used in the command line interface (CI command).
• The | symbol means “or”.
• The entry
in the command lines refers to carriage return. Press [ENTER]
or carriage
return after a command to execute the command.
• Use the up (y) or down (z) arrow key to scroll through the command history list.
• The CLI does not accept partial or incomplete commands. You may enter a unique part of
a command and press
[TAB]
to have the switch automatically display the full command.
For example, if you enter “ config ” and press
[TAB]
, the full command of “ configure ”
automatically displays.
• Each interface refers to an Ethernet port on the switch. Commands configured after the
interface command correspond to those ports.
• Type multiple ports or port ranges separated by a comma. Ranges of port numbers are
typed separated by a dash.
Enter User Name : admin
Enter Password : XXXX