Tektronix AWG610 - Manual (Page 90)

Tutorials
2-52
AWG610 Arbitrary Waveform Generator User Manual
Figure 2-33: The Select File list
4. Push the Drive... side menu button.
The Select Drive dialog box appears at the corner of the screen and the
Drive... side menu also appears. Note that the knob icon appears in the
dialog box. This means that you can use the general purpose knob to select a
drive from the list.
5. Turn the general purpose knob or use the navigation arrow buttons to
highlight the word Floppy and then push the OK side button.
The dialog box now lists the files on the sample waveform floppy disk.
Do the following steps to load a sample waveform:
1. Turn the general purpose knob to select LIN_SWP.WFM from the file listing
in the dialog box.
2. Push the OK side menu button, and wait until the LED of the floppy disk
drive goes off.
This operation loads the selected waveform file into the instrument waveform
memory. Confirm that 8000 is displayed in the Points: display field at the lower
left of the screen and that LIN_SWP.WFM is displayed in the WFM File: display
field.
Load a Sample Waveform