Tektronix AWG610 - Manual (Page 218)

The Table Editor
3-100
AWG610 Arbitrary Waveform Generator User Manual
Position in the data
record, expressed in point
number or time unit.
Value ateach point
Upper cursor position
and data value
Marker1 and Marker2 values
Lower cursor position
and data value
Upper cursor is indicated by U
and lower cursor by L.
The TOGGLE button on the
front panel toggles between
the upper and lower cursors.
Figure 3-22: Table Editor window
Editing The Table Data
The Numeric Input... command in the Operation bottom menu lets you edit
waveform and marker data in the Table Editor. Do the following steps to edit the
waveform or the marker data in the table:
1. Use the general purpose knob or cursor fields to move the active cursor to
the data point that you want to edit.
The active data point is the highlighted row in the table.
2. Push Operation (bottom)
!Numeric Input... (pop-up).
3. To edit waveform data, push the Data side button and change or enter the
data value using the general purpose knob, keyboard, or keypad buttons.
4. To edit the marker data, push the Marker 1 or Marker 2 side button to
toggle between High and Low.
The data in table display mode is the same data that is displayed in the graphic
editors. You can use all applicable bottom menu commands, except for the
Zoom/Pan commands, to manipulate data in the Table Editor mode.