Tektronix AWG610 - Manual (Page 202)

The Pattern Editor
3-84
AWG610 Arbitrary Waveform Generator User Manual
Selecting Data Bits to Edit
Like the waveform editor, the pattern editor executes operation menu commands
on the data between the two cursors. You must select which of the 8 data bit
signals to edit. Selected bits (data and marker) are indicated by highlighting the
data bit and/or marker names at the left of the pattern display area. The selected
bits are referred to as the edit scope. For example, Figure 3–16 shows the edit
scope (selected data bits) as Data5 through Data1. Note that you can only select
contiguous sets of data bits.
Figure 3-16: Operating data bits (scope)
To specify the edit scope, do the following steps:
1. Push Operation (bottom)
!Select Lines (pop-up)!OK (side).
The side menu items From and To appear.
2. Push the From side button and specify the start bit of the scope using the
general purpose knob or numeric buttons.
The option may be Data0 to Data7, Marker1, and Marker2.
3. Push the To side button and specify the end bit of the scope using the general
purpose knob or numeric buttons.
The option may be Data0 to Data7, Marker1, and Marker2.