Tektronix AWG610 - Manual (Page 272)

The UTILITY Window
3-154
AWG610 Arbitrary Waveform Generator User Manual
The GPIB address defines a unique address for the AWG610 Arbitrary Wave-
form Generator. Each device connected to the GPIB bus must have a unique
GPIB address. The GPIB address must be from 0 to 30.
Do the following steps to set the GPIB parameters:
1. Select UTILITY (front-panel)
!Comm (bottom). The screen as shown in
Figure 3–47 appears.
GPIB setup
parameters
Figure 3-47: GPIB setup screen menu
2. Select GPIB for remote control.
a. Select Remote control using
y and b buttons.
b. Select GPIB.
3. Set the GPIB bus connection parameter:
a. Select the GPIB Configuration using
y and b buttons.
b. Select a configuration mode: Talk/Listen, Controller, or Off Bus.
4. Set the instrument GPIB address:
a. Select the GPIB Address using
y and b buttons.
b. Set the GPIB address using the general purpose knob.
Make sure that the value you enter is unique for this GPIB bus.
The changes take effect immediately.