Kodak SRP 30 - Manual (Page 88)

Settings
Coding the Paper Magazine
White slide tabs located on the paper magazine let you code the width (1–4) and
surface (5 and 6) of the paper in use. Whenever you change paper, set the slide tabs
accordingly. The meaning of the coding is described below.
† Slide tab closed (corresponds to switch setting on the SRP 30 screen)
„ Slide tab open (corresponds to switch setting on the SRP 30 screen)
Width Indicators Surface Indicators
Paper Width
1 2 3 4 5 6
3.25 inch (82 mm)
„ † „ †
3.50 inch (89 mm)
„ † „ „
3.75 inch (95 mm)
† „ „ „
4.00 inch (102 mm)
„ „ „ †
4.75 inch (120 mm)
„ „ † „
GLOSSY
„†
5.00 inch (127 mm)
„ † † „
MATTE
„„
6.00 inch (152 mm)
„ † † †
CUSTOM1
†„
6.50 inch (165 mm)
† „ „ †
CUSTOM2
††
7.00 inch (178 mm)
† „ † „
8.00 inch (203 mm)
† † „ „
8.25 inch (210 mm)
† „ † †
8.50 inch (216 mm)
† † † †
10.0 inch (254 mm)
† † † „
11.0 inch (279 mm)
† † „ †
12.0 inch (305 mm)
„ „ † †
NOTE: The table shows the Kodak standard. If required, you can define a different
allocation of the switches to paper widths and surfaces. Each switch
combination can only be used once. (See Paper Configurations on Page
4-51.)
When the magazine is in place, the system automatically recognizes the paper width
and the paper surface and offers the corresponding sizes for selection in the print
menus.
KODAK PROFESSIONAL SRP 30 Laser Printer 4-13