Kodak SRP 30 - Manual (Page 37)

Operator’s Guide
3. Change the start information in the display, if necessary:
•
Change Timer
Change the date and time for the next startup in the opening screen.
•
Next Login
Select the user for the next startup.
NOTE: Changes of the start time and the user are only valid until the next startup.
Permanent changes are only possible using the equipment settings.
4. Perform the daily maintenance procedures. (See Daily Maintenance in
Chapter 8.)
5. Reply to all checks, if any:
a. If unfinished APS orders exist, answer the query as to whether they should
be saved. Orders that are not saved are lost.
b. If orders exist that are not priced, confirm the warning message. All finished
orders are saved, whether or not they are priced.
The equipment is shut down and turned off.
Turning Off the Equipment Partially (Sleep Mode)
It is possible to turn off parts of the system so that only the main computer is running.
This “Sleep” mode allows for statistical checks, locally or by remote control, before
the equipment is turned off completely. While in Sleep mode:
•
The printer and paper processor are OFF.
•
The main computer is ON.
You can activate the Sleep mode for the desired weekdays and enter the switch-off
time of the main computer. When the Sleep mode is activated, the turn-off time of the
main computer is indicated on the monitor.
For more information, see Defining Times for Startup, Shutdown, and Sleep Mode in
Chapter 4.
2-18 KODAK PROFESSIONAL SRP 30 Laser Printer