Kodak SRP 30 - Manual (Page 73)

Operator’s Guide
Stabilizer
1. Add 10.3 L of water to the first tank.
2. Add one-half the contents (approximately 72 mL) of one bottle of stabilizer
concentrate (labeled SB).
3. Repeat Steps 1 and 2 for each of the three remaining stabilizer tanks.
The total volume for each tank is 11 L.
Bleach-Fix
You can mix the working bleach-fix tank directly from the two-part concentrates. Use
two EKTACOLOR Processing Cartridge 75 units to supply the two bottles of each of
the two concentrate solutions.
CAUTION:
IMPORTANT:
Avoid contamination of the developer with bleach-fix.
1. Add 12.7 L of water to the tank.
2. Add the entire contents of two bottles of bleach-fix concentrate, Part A
(labeled BX-A).
3. Add the entire contents of two bottles of bleach-fix concentrate, Part B
(labeled BX-B).
The total volume in the tank is 18.0 L.
Developer
To obtain good performance, take special care in mixing the
developer tank.
1. Add 15.9 L of water to the tank.
2. Slowly add the entire contents of two bottles of developer concentrate
(labeled CD).
3. Add 900 mL of EKTACOLOR RA Developer Starter, Catalog No. 102 6681.
The total volume in the tank is 18.5 L.
Inserting the Chemical Filters
1. Take the chemical filters out of the accessory pack.
2. Rinse the filters in water to remove loose fibers and attach the filters to the
holders.
3. Put them in the appropriate tanks corresponding to the colored stickers. You may
need to turn the filter rods slightly so that the filters sit correctly.
3-6 KODAK PROFESSIONAL SRP 30 Laser Printer