Kodak SRP 30 - Manual (Page 102)

Settings
Paper Processor Settings
Setting the Replenishment Rates
NOTE:
IMPORTANT:
You cannot modify the individual replenishment rates. The rates for DEV, BX
and STB can only be increased or reduced together at the same ratio. If one
of the replenishment rates is changed, the values of the other two solutions
are changed in proportion.
If possible, do not change the preset replenishment rate values. If
required, use Reset to default for all modified values.
1. Touch:
•
Settings
•
Machine settings
•
PP Replenishment
The Normal, Increased, and Maximum replenishment rates for chemicals and
water are indicated at the top of the screen. The system calculates the daily
average throughput of the last five days of production and sets an appropriate
Normal replenishment rate.
More chemicals and water are replenished to maintain production stability when
below average throughput occurs. If the system detects a throughput of less than
10 m
2 , it activates the Increased replenishment rate. If the system detects a
throughput of less than 5 m 2 , it activates the Maximum replenishment rate.
The Normal replenishment rates are increased by the factors or volumes
displayed on the Increased and Maximum replenishment buttons.
2. When the SRP 30 Laser Printer is first put into operation, or if it has not been
used for a number of days, touch Activate normal repl.
After 5 operating days, the replenishment proceeds according to the system-
calculated throughput.
3. Touch OK or Cancel.
KODAK PROFESSIONAL SRP 30 Laser Printer 4-27