Kodak SRP 30 - Manual (Page 71)

Operator’s Guide
CAUTION: To prevent contamination of the chemicals, always fill the tanks
in the following order:
SB
Ö BX Ö CD
After each preparation of a solution, thoroughly rinse the
containers used for the preparation first with cold water, then
with hot water.
Rinsing the Tanks
1. Open the wet section cover.
2. Fill the replenisher tank with water until the lower level sensors are covered to
avoid the request for the connection of an EKTACOLOR Processing Cartridge.
3. Fill all machine tanks with hot water.
4. Let the equipment run for a short while to rinse the circulation system and to
remove any chemical residues.
5. Switch off the equipment and completely drain the cleaning water. Check that all
drain valves are closed firmly.
6. Check the hose positioning. Check that the hose has no:
•
Leaks
•
Sharp bends
•
Crimps
•
Air bubbles
3-4 KODAK PROFESSIONAL SRP 30 Laser Printer