Kodak SRP 30 - Manual (Page 240)

Correcting System Conditions
Error Handling
General
•
Remove errors if the cause is known.
•
Touch Clear if this button is shown.
•
If required, do the procedure Reset Using the Stop Button on the Screen on page
7-5.
•
If the message Reset successful appears, work can be continued. If not, you must
take further action. See below.
Unresolved Errors
1. Touch i to open the error list. All error messages shown in the status line are
saved. The list shows the error messages with the date and time of occurrence.
2. If an error in the paper processor has not been removed, select the error
message and touch Cancel selection.
3. Printer messages mainly refer to paper that has to be removed. Remove the
paper.
4. Disable Show all errors so that only active errors are displayed. Remove and
delete all active errors from the list with Cancel selection.
5. If the system still does not perform a reset automatically, exit the error list and
touch Stop to reset the system manually.
6. If the reset is unsuccessful, open one of the front doors. This causes the system
to display the large error pop-up windows again.
7. If the loop—constantly unrepaired errors—cannot be interrupted, push the ON
key on the scanner.
KODAK PROFESSIONAL SRP 30 Laser Printer 7-7