Mixing the tank solutions, Mixing the tank solutions -5 – Kodak SRP 30 User Manual
Page 72
Chemicals
Mixing the Tank Solutions
The instructions assume that you are mixing the fresh-tank solutions directly in the
processor tank.
WARNING:
Use cold water when you mix solutions to prevent you from
unnecessary exposure to fumes that can be released at higher
temperatures.
Handle all chemicals carefully. When you mix solutions, wear
goggles or a face shield, a protective rubber apron, and
protective gloves made with either neoprene or nitrile rubber.
Clean protective clothing after use to remove any chemical
residue that can cause contamination.
For more information about potential health hazards and safe
handling of specific Kodak chemicals, see the label and the
Material Safety Data Sheet (MSDS) for the chemical. Consult the
MSDS for regional contact information.
MSDS copies are available at the Kodak Web site
IMPORTANT: To make sure that no chemicals splash on the equipment, fasten the
plastic covers from the accessory pack on the equipment.
Open two KODAK EKTACOLOR Processing Cartridge 75 cartons and remove the
four bottles from each carton.
When you remove the cap of a bottle, the label printed on the seal identifies the bottle
as either the developer bottle (CD), one of the two bleach-fix bottles (BX-A or BX-B),
or the stabilizer bottle (SB).
You need:
•
Two bottles of each part to make up the fresh-tank solutions
•
A solution measuring device, such as a graduated cylinder that can accurately
measure volumes up to 900 mL
•
The ability to measure up to 10 L of water
For the developer you need KODAK EKTACOLOR RA Developer Starter. The Kodak
catalog numbers are:
Region CAT
No.
United States, Canada, and Latin
America (Northern)
102 6681
Europe, Middle East, Africa
527 8957
Latin America (Southern)
632 0238
Greater Asia Region
444 5839, 403 6596
China 660
0315
Japan 660
0647
KODAK PROFESSIONAL SRP 30 Laser Printer
3-5