Kodak SRP 30 - Manual (Page 104)

Settings
Production Balance – TFS Logic
1. Touch:
•
Settings
•
Machine settings
•
Production Balance
2. Enable the Color negative production balance function.
IMPORTANT: Modifying the parameters for general machine settings (such as
corrections, grain reduction, and activation of the TFS logic) will shift
the printer result in one direction, but will also have an effect on the
result in the other direction. For this reason, only experienced
operators should modify parameters.
•
These settings only affect color negative handling.
•
Modifications are only effective after a new start.
The settings of the Production balance (surface and detail contrast, sharpness and
saturation, etc.) do not show in the back print because the Production balance
specifies the basic setting (0 value).
Correction values entered later (by way of correction configurations or for image
improvement) are added to this 0 value and can appear in the back print. For color
and density corrections, the weighing depends on the entered correction strength.
(See Impact, below.)
Impact
The Impact button is used for modifying the correction strength:
•
Preset: 100%
•
Range: 10-200%
The preset value of 100% should result in a correction density step of about 0.01D
and a color step of about 0.03D–0.04D on the paper (depending on the paper
KODAK PROFESSIONAL SRP 30 Laser Printer 4-29