Kodak SRP 30 - Manual (Page 303)

Operator’s Guide
Changing the Ink Ribbon on the Back Printer
Replace the ink ribbon when the printing on the back of the prints becomes too
faded.
1. Unscrew the locking screw (1, red) of the lane distributor.
2. Pull out the unit on the telescopic rails.
3. Loosen the knurled screws (2) and remove the top cover of the back printer.
4. Remove the ink ribbon cartridge by slightly pushing in both sides (3).
5. Prepare the new ink ribbon cartridge:
If present, remove the foil strip on the ink ribbon. The ink ribbon must be tight in
the cartridge; if necessary tighten by the knob (4) (note the direction indicated by
the arrow).
6. Insert the ink ribbon cartridge.
7. Slightly turn the knob (4) on the cartridge until you hear the cartridge lock in.
8. Push in the lane distributor and tighten the locking screw.
8-50 KODAK PROFESSIONAL SRP 30 Laser Printer