Kodak SRP 30 - Manual (Page 178)

Production
Changing the Paper Magazine
IMPORTANT: Always wait 30 seconds after the last print procedure before
removing the magazine to let the paper rewind into the magazine.
The LED in front of the magazine indicates when you may remove the magazine:
Green = yes
Red = no
1. Open the printer door.
2. Remove the paper magazine:
a. Push the locking lever to the side.
b. Pull out the paper magazine.
3. Insert the paper magazine:
a. Put the paper magazine in the guide rails and slowly push it in until it locks.
CAUTION:
IMPORTANT:
IMPORTANT:
Excessive insertion force on the paper magazine can cause
damage to the drive gear.
b. Close the printer door.
4. Reply to the check of the paper cut.
To avoid paper transport malfunctions due to an incorrectly cut paper
tip, the prompt should be confirmed in the following cases:
•
When a new paper roll is inserted
•
When a paper jam has occurred
If the paper is to be cut, the machine cuts the paper tip, turns it 180° and transports it
to the print engine.
Whenever a magazine is inserted, the system checks the paper
length by moving the paper to the cutter and back. Make certain that
the middle printer door remains closed during this procedure to
prevent the paper from becoming pre-exposed.
The paper is ready for use when the indicator LED (visible through the gap between
the printer door and outer panel) changes from red to green.
KODAK PROFESSIONAL SRP 30 Laser Printer 6-7