Motorola 68P02958C00-B - Manual (Page 304)

Software Diagnostics Output
C-12
## 113 LEVEL = 1
Address 0 to transmit in same snapshot : %% 1
Address 1 to transmit in same snapshot : %% 1
Address 2 to transmit in same snapshot : %% 1
Address 3 to transmit in same snapshot : %% 1
Network device key : %% 2
Physical device key : %% 3
Physical pin’s table : %% 3
Last reported station in fail : %% 4
Port fail flag : %% 5
‘one to one’ flag : %% 6
Full duplex flag : %% 7
# of frames in Tx queue : %% 8
# of frames in ‘wait for ack’ queue : %% 9
# of frames in ‘busy & setcall’ queue : %% 10
# of frames in ‘busy & finish’ queue : %% 11
‘private conversation’ flag : %% 12
1. The Link layer is capable of sending to up to four different addresses simultaneously. These fields
contain the last four target addresses transmitted in the same transmission.
2. The Network layer key.
3. The pins table and key of the Physical layer below link. The Link layer is capable of connecting to
any of the different physical media.
4. The last unit that has been reported to be in fail state.
5. The physical port in fail.
6. Mark if the link answers to the local address.
7. Mark if the link is full duplex.
8. The number of frames currently in the Tx queue.
9. The number of frames currently in the Wait for ACK queue .
10. The number of frames currently in the Busy and Broadcast queue that are waiting for the timeout
between retries.
11. The number of frames waiting for the timeout between retries to be over and to be transmitted before
new data frames waiting in the Tx queue.
12. Whether link functions in the private conversation mode (not in use in RTU).
## 115 LEVEL = 10/11
# of transmitted frames : %% 1
# of re-transmitted frames : %% 2
# of received frames : %% 3
# of received frames (with error) : %%
1. The # of Transmitted Frames does not include retransmission and acknowledgment frames.