Motorola 68P02958C00-B - Manual (Page 298)

Software Diagnostics Output
C-6
## 49 LEVEL = 10,11
# of transmitted frames : %% 1
# of transmission fails : %% 2
# of received frames : %% 3
# of received frames (with error) : %% 4
Mask of errors (receive) : %% 5
Number of non-properly authenticated SYNC frames : %% 6
1. The number of unformatted frames that have been transmitted.
2. The number of unformatted frames that have been transmitted and for which the physical layer
returned a fail signal.
3. The number of received frames includes only correct frames (including acknowledgment frames).
4. The number of unformatted frames that have been received with some error.
5. The following figure illustrates the mask:
6. Number of synchronization frames which were not properly authenticated.
b15 . . . . . . . . . . b8 b7 b6 b5 b4 b3 b2 b1 b0
Res
e
rv
ed
unformatted buffer heap is empty
inverse byte, end of frame
empty frame received
invalid destination
frame, more than 200 bytes
inverse byte, inverse byte
invalid byte after inverse byte
CRC error
Recovery of UF heap
TRANSPORT DEVICE = TRANS1, TRANS2,...
## 64 LEVEL = 0
Logical channel no. : %% 1
Timeout between Tx retries : %% 2
Timeout between channel busy retries : %% 3
Timeout between Rx frames : %% 4
Timeout of Rx wait (till session chk) : %% 5
Current timeout between Tx retries : %% 6
Current timeout between channel busy retries : %% 7
Current timeout between Rx frames : %% 8
Current timeout of Rx waiting : %% 9
No. of Tx retries : %% 10
No. of channel busy retries : %% 11
Current no. of Tx retries : %% 12