Motorola 68P02958C00-B - Manual (Page 155)

SNMP Configurator
5-98
Upload
The Upload command is used to read the SNMP configuration of a site into Toolbox. You can
upload from the IP Gateway directly connected to the Toolbox computer, or from a remote IP
Gateway unit.
Before you activate the Upload command, ensure that the Toolbox computer is ready to
communicate. After you select Upload, Toolbox asks you to specify the communication
password, if this is the first time that the Communication Driver is used. If the Communication
Driver was activated before, no password is required. Following the entry of the correct
password, the Upload SNMP Configuration dialog is displayed.
Local
If the Toolbox computer is locally connected to the IP Gateway, select this parameter.
Remote
If you want to upload the configuration of a remote site, click this parameter.
Site ID, Link ID
To upload the configuration of a remote site, specify its Site ID, then open the Link ID drop-
down list and select the appropriate Link ID. The Toolbox displays the following screen.