ITC IRMA TruPoint Blood Analysis System - Manual (Page 98)

7.2
TEST SETTINGS
QA Users can access Test Settings by pressing
Test from the SETTING OPTIONS menu. A TEST
SETTINGS picklist displays. Current test settings
can be viewed or changed by highlighting a
category in the TEST SETTINGS picklist and
pressing
edit .
PRODUCT SETUP
QA Users can use the Product Setup option to:
• Define the product types that are in use at their facility. With each
patient test, the user is prompted to enter the product type being run. Only
those product types defined in the Product Setup option will appear on the
Select Product Type screen with each test; if a single product type is
defined, the analyzer assumes that all cartridges inserted for testing are of
that type, and no Select Product Type screen will appear.
• Define the analytes that will be reported for each cartridge type. Note
that all analytes will always be reported for BG cartridges.
Defining the product type(s) in use
1. Highlight Product Setup in the picklist and
press edit .
2. Highlight each Product Type that will be used
at your site. Press next to define which
analytes will be reported for each cartridge
type.
Defining analytes to be reported for each cartridge type.
• Define which analytes will be reported for each CC test:
1. Highlight the analytes to be reported
automatically with each CC test. Press next .
2. If the analytes to be reported will vary from
test-to-test, highlight User Selects . This will
prompt individual selection of analytes or
analyte groupings with each CC test. Press
next .