ITC IRMA TruPoint Blood Analysis System - Manual (Page 100)

7.4
5. Enter the Cal code and press next to return to
the Lot picklist. Press done to return to TEST
SETTINGS.
Note:
• New product lots that are entered via patient test or QC test will appear
in the Lot picklist following entry.
Replacing an existing product lot with a new product lot
1. Highlight Lot Entry and press edit . Highlight the appropriate product type
and press next . Scroll down the picklist until the existing lot number is
highlighted. Press edit .
2. Enter the new lot code and press next . Enter the new Cal Code and press
next to return to the Lot picklist. The new lot replaces the old lot in the
picklist. Press done to return to TEST SETTINGS.
CALCULATIONS
QA Users can define the calculated values to be reported with each test, and
the formulas used to derive the calculated values using the Calculations
option.
Defining the calculated values to be reported with each patient test
1. Highlight Calculations and press edit .
2. Highlight Calculated Values from the picklist
and press edit .
3. Highlight the calculated values to be reported
(depends on product type) with each patient
test, and press
next .
If BEb was not selected, Calculated Values
setup is complete.