Solution 6: contact hp support – HP Photosmart D5400 series User Manual
Page 89
If this did not solve the issue, try the next solution.
Solution 6: Contact HP support
Solution: Contact HP support for service.
Go to
.
If prompted, choose your country/region, and then click Contact HP for information
on calling for technical support.
Cause: There was a problem with the print head.
The printout has a horizontal band of distortion near the bottom of a borderless
print
Try the following solutions if your borderless print has a blurry band or line on the bottom
of it.
NOTE:
For this issue, there is not a problem with your ink supplies. Therefore,
replacing the ink cartridges or print head is not necessary.
•
Solution 1: Check the paper type
•
Solution 2: Use a higher print quality setting
•
Solution 1: Check the paper type
Solution: HP recommends that you use HP papers or any other paper type that is
appropriate for the product.
Always make sure the paper you are printing on is flat. For best results when printing
images, use HP Advanced Photo Paper.
Store photo media in its original packaging inside a resealable plastic bag on a flat
surface in a cool, dry place. When you are ready to print, remove only the paper you
plan to use immediately. When you have finished printing, return any unused photo
paper to the plastic bag. This will prevent the photo paper from curling.
NOTE:
There is no problem with the ink supplies and replacing the print
cartridges is unnecessary.
For more information, see:
•
“Recommended papers for printing” on page 15
•
“Information on paper” on page 81
Cause: The wrong kind of paper was loaded in the input tray.
If this did not solve the issue, try the next solution.
Solution 2: Use a higher print quality setting
Solution: Check the print quality setting and make sure it is not set too low.
Chapter 11
88
Troubleshooting
T
roub
les
hoot
ing