beautypg.com

HP Photosmart D5400 series User Manual

Page 192

background image

The print carriage moves to the center of the product.

NOTE:

Wait until the print carriage stops moving before proceeding.

4.

Locate the sensor inside the product.
The sensor is a square, black plastic part slightly larger than a pencil eraser, just
to the left of the print carriage.

5.

Wipe the sensor with a dry swab or lint-free cloth.

6.

Close the ink cartridge access door, and check if the error message has been
resolved.

7.

If you still receive the error message, turn the product off, and then on again.

Cause: Ink might have built up and covered the sensor.
If this did not solve the issue, try the next solution.

Solution 2: Clean the sensor windows on the ink cartridges

Solution: Clean the sensor window on all of the ink cartridges.
If the problem is not resolved, printing can continue, but the ink system behavior might
change.

CAUTION:

The cleaning procedure should take only a few minutes. Make sure

that the ink cartridges are reinstalled in the product when instructed. Leaving them
outside of the product for an extended period of time can result in damage to the
ink cartridges.

To clean the sensor window on the ink cartridges

1.

Gather swabs or a lint-free cloth to use for the cleaning procedure.

2.

Make sure the product is turned on.

3.

Open the ink cartridge access door by lifting from the front right of the product,
until the door locks into place.

Errors

191

Trou

bles

ho

ot

ing

This manual is related to the following products: