beautypg.com

Solution 2: remove objects blocking the path – HP Photosmart D5400 series User Manual

Page 153

background image

Print quality pattern: displays the color blocks, representing each of the
installed ink cartridges. Solid, even blocks of color indicate there are no print
quality problems. When streaks are displayed or there are missing blocks,
clean the print head using the procedure described in

“Clean the print head”

on page 64

. If the color blocks still show print quality problems after cleaning

the print head, align the product using the procedure described in

“Align the

print head” on page 64

. If the color blocks continue to show print quality

problems after cleaning and aligning, contact HP customer support.

History log: contains information that might be used for diagnostic purposes
if you need to call HP customer support.

If the product can print a self-test report and can print from the computer (if applicable),
then there is no need to follow the remaining solutions, as the error message might
be false.
Cause: The error was false.
If this did not solve the issue, try the next solution.

Solution 2: Remove objects blocking the path

Solution: Remove any objects, such as paper, that are blocking the print carriage
path. Then reset the product.

To clear the print carriage

1.

Leave the product on and then disconnect the power cord and the USB cable
from the back of the product.

CAUTION:

Make sure the product is on before disconnecting the power

cord. Failure to disconnect the power cord from the rear of the product can
cause damage when removing jammed paper. Do not reconnect the power
cord and USB cable until instructed to later.

2.

Open the ink cartridge access door by lifting from the front center of the product,
until the door locks into place.

Chapter 11

152

Troubleshooting

T

roub
les
hoot

ing

This manual is related to the following products: