beautypg.com

Paper jam or misfeed, Solution 6: contact hp support for service – HP Photosmart D5400 series User Manual

Page 145

background image

3.

Dip the lint-free cloth into the purified or distilled water, and squeeze any excess
water from it.

4.

Clean the rubber rollers to remove any dust or dirt buildup.

5.

Replace the rear door. Gently push the door forward until it snaps into place.

6.

Plug the power cord back in, and turn on the product.

7.

Try to print again.

Cause: The rollers were dirty and needed to be cleaned.
If this did not solve the issue, try the next solution.

Solution 6: Contact HP support for service

Solution: If you have completed all of the steps provided in the previous solutions
and are still having a problem, contact HP support for service.
Go to:

www.hp.com/support

.

If prompted, choose your country/region, and then click Contact HP for technical
support.
Cause: You might need assistance to enable the product or software to function
properly.

Paper jam or misfeed

Solution: In case of a paper jam, check the rear door. You might need to clear the
paper jam from the rear door.

To clear a paper jam from the rear door

1.

Press in the tab on the left side of the rear door to release the door. Remove the
door by pulling it away from the product.

2.

Gently pull the paper out of the rollers.

CAUTION:

If the paper tears when you are removing it from the rollers, check

the rollers and wheels for torn pieces of paper that might be remaining inside
the product. If you do not remove all the pieces of paper from the product,
more paper jams are likely to occur.

Chapter 11

144

Troubleshooting

T

roub
les
hoot

ing

This manual is related to the following products: