Epiphan Pearl Mini Live Video Production System with 512GB SSD (NA/JP) - Manual (Page 234)

Pearl Mini User Guide Connect an SRT stream as an input
source stream is using caller mode, then set the SRT input in the Admin panel to listener mode. For more
information about SRT modes, see
About streaming using SRT .
What's needed for this setup
l The IP address and SRT port of the SRT source (encoder) is needed for caller mode and rendezvous
mode.
l For rendezvous mode, you must configure the SRT input to use the same port value as the SRT source.
For an example SRT stream using rendezvous mode, see
Set up an SRT stream using rendezvous mode .
l For caller/listener modes, you must know which mode the SRT source uses and configure the SRT input
on Pearl Mini to use the corresponding mode.
l Caller mode can be used only for connection with the publicly accessed destination/source.
l Listener mode can be used for connection with any source/destination (including within a local
network behind the firewall).
l For example, if the SRT source is in caller mode, then the input must be in listener mode. For an
example SRT stream using caller/listener modes, see
Set up an SRT stream using caller and
listener modes .
l If AES encryption and a passphrase is required, consult your IT administrator for this information. Pearl
Mini supports 128 bits, 192 bits, and 256 bits AES encryption. Special characters are not supported in the
passphrase.
If AES encryption and a passphrase is configured, ensure this information is provided to the SRT
source. The SRT stream from the source must use the same AES and passphrase values, see
Set
AES encryption and a passphrase for SRT .
Add an SRT stream as an input using the Admin panel
1. Log in to the Admin panel as admin, see Connect to the Admin panel .
2. From the Inputs menu, select Add input and select Add SRT input. The SRT input configuration page
opens.
223