Grass Valley XtenDD v.4.2.4 - Manual (Page 58)

2. Panel Operation
2 – 29 Operating Instructions – Rev. 1 / 7.2002
2.6.2 USER PROGRAMMABLE KEYS IN THE TRANSITION PANEL (UPK)
The function of some buttons in the transition panel can be changed as an environ-
ment setting. This is done in the panel setup (refer to section 4.4.3) or by menu con-
trol (software release V2.0.0).
For details refer also to 2.17. The default inlay set is shown on page 2 – 21.
The available and default functions for a specific button are listed below.
Button
name Default
function Possible
function
Limit Set Limit Set
•
Limit Set
•
Limit On
•
Next Transition Misc1
• Next Transition Misc2
• Insert Key 1 (Start Auto Key1)
• Insert Key 2 (Start Auto Key2)
•
Key 3 (for RPD 35-4 panel without Key 3 button)
Limit On Limit On same as Limit Set
BLK Pst enable/disable
V Fade 2 • enable/disable V-Fade 1
• enable/disable V-Fade 2
• enable/disable V-Fade 3
•
enable/disable V-Fade 4
The transition type buttons are also programmable.
Button
from left Default
function Possible
function
1. DVE
•
ADD
•
Mix
•
Wipe1
• Wipe2
• DVE
2. Mix as above
3. Wipe 1 as above
4. Wipe 2 • as above and
• enable/disable V-Fade 1
• enable/disable V-Fade 2
•
enable/disable V-Fade 3
•
enable/disable V-Fade 4
In addition the function of the buttons CUT and AUTO can be exchanged in the
Install Panel menu with the setting CUT/AUTO Button Position. The value can
be Cut Button Right or Cut Button Left.