Grass Valley XtenDD v.4.2.4 - Manual (Page 387)

3. Menu Operation
3 – 240 Operating Instructions – Rev. 1 / 7.2002
D
Auto Aux Preview: On/Off
Enable or disable the Auto PVW mode. In enabled condition the key PVW,
mask PVW or the chroma key cursor signal of the respective mixing level is
switched on the PVW bus.
D
KeyMemory AutoSave: On/Off
If the KeyMemo button is switched on in a Keyers menu, the key memory is
always recalled if the key sources are changed during control panel operation.
These changes can occur directly by selecting another key source or also indi-
rectly by changing the Fill source or the Split mode.
For storing the key settings in the key memory two modes are available:
1. Auto Save
If the switch Key Memory AutoSave=On, the settings of the previous key si-
gnal are stored automatically before the settings of the next key are recalled.
If the switch Key Memory AutoSave=Off, the stored settings of the new key
are recalled without saving the previous settings.
2. Manual storing
Key Memory AutoSave=Off. For storing the current settings into the key me-
mory, press the button of the respective Fill source approx. 2 seconds. The stor-
ing is confirmed by a short beep in the control panel.
For details refer to section 2.7.7
D
H/V Blanking
The Modify button can be used to switch over between transparent and
blanked. In blanked position the V-gap and the H-gap is replaced by BLACK
and the DD35-internal sync frame is added. In transparent position the
information contained in the V-gap (VITS, videotext etc.) are kept.
This function can be selected for each output and aux busses separately