Grass Valley XtenDD v.4.2.4 - Manual (Page 425)

3. Menu Operation
3 – 278 Operating Instructions – Rev. 1 / 7.2002
Depending whether the command deals with a switch value, an analog value, or
an event you will find one of the following selection pop–ups:
Switch value (e.g. Wipe Rotation Mode):
Set by value Sets rotation mode to a fixed value.
Next selection will be: Angle / Speed / Coupled
Toggle up When you execute this macro, the result depends on the actual
state:
when Angle > Speed
when Speed > Coupled
when Coupled > Coupled
some parameters allow “wrap around”.
In this case Coupled would change to Angle.
“On/Off” parameters always allow “wrap around”.
Toggle down When you execute this macro, the result depends on the actual
state:
when Coupled > Speed
when Speed > Angle
when Angle > Angle
some parameters allow “wrap around”.
In this case Angle would change to Coupled.
“On/Off” parameters always allow “wrap around”.
When you learn macros via the control panel, you will find out that some commands
are learned as “set by value” and others by “toggle” (e.g. “on/off” command).
When you create the commands directly in the command editor you have the
choice to select the way most convenient to you.