Grass Valley XtenDD v.4.2.4 - Manual (Page 411)

3. Menu Operation
3 – 264 Operating Instructions – Rev. 1 / 7.2002
The vertical cursor softkeys and the vertical cursor digipot are used to navigate
within a list box. The complete cursor control is always relevant.
How to store a macro:
D
Make sure that in the Config menu the Running Application is selected to
witch you want to add the macros. If the cursor is not on a Running Applica-
tion the menu item menu
is disabled.
D
Select with the cursor button
↑ ↓
, the digipot or by mouse click a free Key No.
in the Make Memo list field.
D
Push Record button to start recording the macro. Push the desired control
panel buttons and adjust the desired digipots. If a pause is needed between
commands, push the Insert Pause and select the desired time (0.5, 1.0, 2.0,
3.0 or 5.0 in seconds), then proceed with the commands. At the end of the
macro push Record again to stop recording.
Note: If no pause is inserted all commands were executed immediately.
D
If you want to rename the stored commands push Modify and select Rename
in the overlay. Type in the name with the keyboard overlay.
D
To copy a macro to another Key No. select the macro and push Modify. Select
Copy in the overlay. Type in the desired Key No. and confirm with Enter.
D
Macros can also be swapped by selecting Swap in the Modify overlay.
D
To delete a macro select the macro in the list, push Modify and select Delete.
It is possible to assign other busses to the Make buttons in the control panel., e.g.
Aux busses. Select Key All and push Modify. Select from the overlay the bus you
want to assign to these buttons.
Transfer the selected macro from one button to another.
Cursor
↑ ↓
Transfer Key