Grass Valley XtenDD v.4.2.4 - Manual (Page 396)

3. Menu Operation
3 – 249 Operating Instructions – Rev. 1 / 7.2002
With button Modify the following parameters are selectable:
D
Operation Mode
Defines the general operation mode for M/E:
act as M/E or act as P/P
D
Cleanfeed defines the Re-Entry-feed in P/P.
D
Look-Ahead PVW
Defines the signal for PVW output:
OFF PVW output = ME output
ON PVW output = Look-Ahead PVW
OnAir PVW ME on air: PVW output = Look-Ahead PVW
ME not on air: PVW output = ME output
D
Clean 2 Out
Defines the effect of Cleanfeed 2, if Cleanfeed 2 is enabled by Fx-send settings:
PGM Out
BGD only
BGD + Under-key
BGD + Key1 + Key 2
BGD + Key1 + Key2 + Key3
D
Black Preset Abort (Enable/Disable)
When another program source is selected a currently running transition with
BLK PST on will be aborted, the BLK PST button lamp turns off and the se-
lected source is taken as program.
In Layered mode:
If a currently running transition with BLK PST on is at the black limit, it will be
aborted, the BLK PST button lamp turns off, the switcher changes to non-lay-
ered mode and the selected source is taken as program.
D
Transition Abort (Enable/Disable)
When another program source is selected a currently running transition will be
aborted and the selected source is taken as program. Only available in non-lay-
ered mode.
D
FTB Cancel (Enable/Disable)
When another program source is selected an active fade-to-black will be in-
stantly cancelled, so that the image with the selected source is visible on the
stages program output. Only available in non-layered mode.
D
Auto Trans. Abord Inhibit
In On state, a Auto Transition can not stoppt by pressing the Auto button again.
D
Key Drop ...
The selected keys will be dropped, i.e. cutout, when another program source
is selected. Mainly used for DSKs.