Grass Valley XtenDD v.4.2.4 - Manual (Page 447)

3. Menu Operation
3 – 300 Operating Instructions – Rev. 1 / 7.2002
Parameters: Frames
Parameters: GPI No.
The loop can be changed on the Loop Begin as well on the Loop End symbol
Parameters: Loop count
Parameters: –
Parameters: Time of Day
Parameters: GPIONo.
Parameters: Machine 1
Commands: Play, Stop, FFWD, FREW 1
Parameters: Machine 1
Commands: Play, Stop, FFWD, FREW, Cue In, Cue Out, Goto,
Variable
1
Speed: only with command “Variable” 2
Timecode: only with command “Goto” 2
Parameters: Machine 1
Commands: Play, Stop, FFWD, FREW, Goto, Variable 1
Speed: only with command “Variable” 2
Timecode: only with command “Goto” 2
Default Register [yes/no]
“Yes” means that the command is applied to the
register just being selected in the TiM/E Memo
control field.
Register No [0 ... 99]
“No” means that the command is applied to the
register indicated under the register no.
1 The parameter is already defined via the overlay menu.
2 Entry only possible with certain commands
Wait Frames
Wait GPI
Loop End
Wait User
Wait TOD
Trigger GPO
Trigger DVE
Trigger Machine MP
Trigger Memo