H3C Technologies H3C SR8800 - Manual (Page 81)

69
Task Command Remarks
3. View the brief information of
the NTP servers from the local
router back to the primary
reference source.
display ntp-service trace [ | { begin
| exclude | include }
regular-expression ]
Available in any view
NTP configuration examples
NOTE:
Unless otherwise specified, the examples given in this section apply to all switches and routers that support
NTP.
Configuring NTP client/server mode
Network requirements
Perform the following configurations to synchronize the time between Device B and Device A:
• As shown in Figure 25 , the local clock of Device A is to be used as a reference source, with the
stratum level of 2.
• Device B works in the client/server mode and Device A is to be used as the NTP server of Device
B.
Figure 25 Network diagram
Configuration procedure
1. Set the IP address for each interface as shown in Figure 25 . (Details not shown)
2. Configure Device A:
# Specify the local clock as the reference source, with the stratum level of 2.
system-view
[DeviceA] ntp-service refclock-master 2
3. Configure Device B:
# View the NTP status of Device B before clock synchronization.
display ntp-service status
Clock status: unsynchronized
Clock stratum: 16
Reference clock ID: none
Nominal frequency: 64.0000 Hz
Actual frequency: 64.0000 Hz
Clock precision: 2^7
Clock offset: 0.0000 ms
Root delay: 0.00 ms
Root dispersion: 0.00 ms