H3C Technologies H3C SR8800 - Manual (Page 177)

165
IPv6 NetStream aggregation data export configuration
example
Network requirements
As shown in Figure 58 , configure IPv6 NetStream on Router A so that:
• Router A exports IPv6 NetStream traditional data in version 9 format to port 5000 of the NetStream
server at 3.1.1.2/16.
• Router A performs IPv6 NetStream aggregation in the modes of AS, protocol-port, source-prefix,
destination-prefix and prefix. Send the aggregation data to the destination address with DUP port
2000, 3000, 4000, 6000, and 7000 for different modes.
NOTE:
All the routers in the network are running IPv6 EBGP. For more information about IPv6 BGP, see Layer
3—IP Routing Configuration Guide.
Figure 58 Network diagram
Configuration procedure
# Configure interfaces GigabitEthernet 1/1/1 and GigabitEthernet 1/1/2.
system-view
[RouterA] ipv6
[RouterA] interface GigabitEthernet 1/1/1
[RouterA-GigabitEthernet1/1/1] ipv6 address 15::2 64
[RouterA-GigabitEthernet1/1/1] quit
[RouterA] interface GigabitEthernet 1/1/2
[RouterA-GigabitEthernet1/1/2] ipv6 address 20::1 64
[RouterA-GigabitEthernet1/1/2] quit
[RouterA] interface GigabitEthernet 1/1/3
[RouterA-GigabitEthernet1/1/2] ip address 3.1.1.1 255.255.0.0
[RouterA-GigabitEthernet1/1/2] quit
# Configure a QoS policy to mirror traffic entering GigabitEthernet 1/1/1 to NetStream interface
2/0/1.
[RouterA] acl ipv6 number 2000
[RouterA-acl6-basic-2000] rule 1 permit source any
[RouterA-acl6-basic-2000] quit