H3C Technologies H3C SR8800 - Manual (Page 178)

166
[RouterA] traffic classifier ns_ipv6
[RouterA-classifier-ns_ipv6] if-match acl ipv6 2000
[RouterA-classifier-ns_ipv6] quit
[RouterA] traffic behavior ns_ipv6
[RouterA-behavior-ns_ipv6] mirror-to interface Net-Stream 2/0/1
[RouterA-behavior-ns_ipv6] quit
[RouterA] qos policy ns_ipv6
[RouterA-qospolicy-ns_ipv6] classifier ns_ipv6 behavior ns_ipv6
[RouterA-qospolicy-ns_ipv6] quit
# Apply the QoS policy to the inbound direction of GigabitEthernet 1/1/1.
[RouterA] int GigabitEthernet1/1/1
[RouterA-GigabitEthernet1/1/1] qos apply policy ns_ipv6 inbound
[RouterA-GigabitEthernet1/1/1] quit
# Enable IPv6 NetStream.
[RouterA] ipv6 netstream
# Configure to export IPv6 NetStream data in version 9 format and specify the data to include the source
AS, destination AS, and the BGP next hop.
[RouterA] ipv6 netstream export version 9 origin-as bgp-nexthop
# Configure the maximum entries that the cache can accommodate as 409600.
[RouterA] ipv6 netstream max-entry 409600
# In system view, configure the destination address for the IPv6 NetStream traditional data export with
the IP address 3.1.1.2 and port 5000.
[RouterA] ipv6 netstream export host 3.1.1.2 5000
[RouterA] ipv6 netstream export source interface GigabitEthernet 1/1/2
# Configure the aggregation mode as AS, and in aggregation view configure the destination address for
the IPv6 NetStream AS aggregation data export.
[RouterA] ipv6 netstream aggregation as
[RouterA-ns6-aggregation-as] enable
[RouterA-ns6-aggregation-as] ipv6 netstream export host 3.1.1.2 2000
[RouterA-ns6-aggregation-as] quit
# Configure the aggregation mode as protocol-port, and in aggregation view configure the destination
address for the IPv6 NetStream protocol-port aggregation data export.
[RouterA] ipv6 netstream aggregation protocol-port
[RouterA-ns6-aggregation-protport] enable
[RouterA-ns6-aggregation-protport] ipv6 netstream export host 3.1.1.2 3000
[RouterA-ns6-aggregation-protport] quit
# Configure the aggregation mode as source-prefix, and in aggregation view configure the destination
address for the IPv6 NetStream source-prefix aggregation data export.
[RouterA] ipv6 netstream aggregation source-prefix
[RouterA-ns6-aggregation-srcpre] enable
[RouterA-ns6-aggregation-srcpre] ipv6 netstream export host 3.1.1.2 4000
[RouterA-ns6-aggregation-srcpre] quit
# Configure the aggregation mode as destination-prefix, and in aggregation view configure the
destination address for the IPv6 NetStream destination-prefix aggregation data export.
[RouterA] ipv6 netstream aggregation destination-prefix