H3C Technologies H3C SR8800 - Manual (Page 141)

129
[DeviceB-GigabitEthernet3/0/1] port trunk permit vlan 2
[DeviceB-GigabitEthernet3/0/1] quit
# Configure GigabitEthernet 3/0/2 as a trunk port that permits the packets of VLAN 2 to pass
through.
[DeviceB] interface GigabitEthernet3/0/2
[DeviceB-GigabitEthernet3/0/2] port link-type trunk
[DeviceB-GigabitEthernet3/0/2] port trunk permit vlan 2
[DeviceB-GigabitEthernet3/0/2] quit
3. Configure Device C (the destination device):
# Configure GigabitEthernet 3/0/1 as a trunk port that permits the packets of VLAN 2 to pass
through.
system-view
[DeviceC] interface GigabitEthernet3/0/1
[DeviceC-GigabitEthernet3/0/1] port link-type trunk
[DeviceC-GigabitEthernet3/0/1] port trunk permit vlan 2
[DeviceC-GigabitEthernet3/0/1] quit
# Create a remote destination group.
[DeviceC] mirroring-group 1 remote-destination
# Create VLAN 2.
[DeviceC] vlan 2
[DeviceC-vlan2] quit
# Configure VLAN 2 as the remote probe VLAN of the mirroring group and GigabitEthernet
3/0/2 as the monitor port of the mirroring group, disable the spanning tree feature on
GigabitEthernet 3/0/2, and assign the port to VLAN 2.
[DeviceC] mirroring-group 1 remote-probe vlan 2
[DeviceC] interface GigabitEthernet3/0/2
[DeviceC-GigabitEthernet3/0/2] mirroring-group 1 monitor-port
[DeviceC-GigabitEthernet3/0/2] undo stp enable
[DeviceC-GigabitEthernet3/0/2] port access vlan 2
[DeviceC-GigabitEthernet3/0/2] quit
4. Verify the configuration:
After the configurations are completed, you can monitor all the packets received and sent by the
marketing department on the server.