H3C Technologies H3C SR8800 - Manual (Page 29)

17
Step Command Remarks
5. Configure the source IP
address of FTP request
packets.
source ip ip-address
By default, no source IP address is
specified.
The source IP address must be the
IP address of a local interface. The
local interface must be up;
otherwise, no FTP requests can be
sent out.
6. Configure the operation type. operation { get | put }
Optional.
By default, the operation type for
the FTP is get, which means
obtaining files from the FTP server.
7. Configure a login username. username name
By default, no login username is
configured.
8. Configure a login password. password password
By default, no login password is
configured.
9. Specify a file to be transferred
between the FTP server and
the FTP client.
filename file-name By default, no file is specified.
10. Set the data transmission
mode for FTP tests.
mode { active | passive }
Optional.
active by default.
11. Configure optional
parameters.
See “ Configuring optional
parameters for an NQA test
group
”
Optional.
NOTE:
•
When you execute the put command, a file file-name with fixed size and content is created on the FTP
server. When you execute the get command, the device does not save the files obtained from the FTP
server.
• When you download a file that does not exist on the FTP server, FTP tests fail.
• When you execute the get command, use a file with a small size. A big file may result in test failure due
to timeout, or may affect other services for occupying too much network bandwidth.
Configuring HTTP tests
HTTP tests of an NQA test group are used to test the connection between the NQA client and an HTTP
server and the time required to obtain data from the HTTP server. HTTP tests enable you to detect the
connectivity and performance of the HTTP server.
Configuration prerequisites
Before you start HTTP tests, configure the HTTP server.
Configuring HTTP tests
To configure HTTP tests: