H3C Technologies H3C SR8800 - Manual (Page 160)

148
Configuration procedure
# Configure a QoS policy to mirror traffic entering GigabitEthernet 6/1/7 to NetStream interface
2/0/1.
[RouterA] acl number 2005
[RouterA-acl-basic-2005] rule 1 permit source any
[RouterA-acl-basic-2005] quit
[RouterA] traffic classifier ns_ipv4
[RouterA-classifier-ns_ipv4] if-match acl 2005
[RouterA-classifier-ns_ipv4] quit
[RouterA] traffic behavior ns_ipv4
[RouterA-behavior-ns_ipv4] mirror-to interface Net-Stream 2/0/1
[RouterA-behavior-ns_ipv4] quit
[RouterA] qos policy ns_ipv4
[RouterA-qospolicy-ns_ipv4] classifier ns_ipv4 behavior ns_ipv4
[RouterA-qospolicy-ns_ipv4] quit
# Apply the QoS policy to the inbound direction of GigabitEthernet 6/1/7.
[RouterA] interface GigabitEthernet6/1/7
[RouterA-GigabitEthernet6/1/7] qos apply policy ns_ipv4 inbound
[RouterA-GigabitEthernet6/1/7] quit
# Enable NetStream on Router A. Specify to export NetStream data to IP address 12.110.2.2 and port
5000 (the NetStream server), leaving the default for source address.
[RouterA] ip netstream
[RouterA] ip netstream export host 12.110.2.2 5000
NetStream aggregation data export configuration example
Network requirements
As shown in Figure 54 , configure NetStream on Router A so that:
• Router A exports NetStream traditional data in version 5 format to port 5000 of the NetStream
server at 4.1.1.1/16.
• Router A performs NetStream aggregation in the modes of AS, protocol-port, source-prefix,
destination-prefix and prefix. Use version 8 export format to send the aggregation data of different
modes to the destination address at 4.1.1.1, with UDP port 2000, 3000, 4000, 6000, and 7000
respectively.
NOTE:
All the routers in the network are running EBGP. For more information about BGP, see Layer 3—IP Routing
Configuration Guide.