H3C Technologies H3C SR8800 - Manual (Page 33)

21
Step Command Remarks
6. Configure the source IP
address of SNMP packets.
source ip ip-address
Optional.
By default, no source IP address is
specified.
The source IP address must be the
IP address of a local interface. The
local interface must be up;
otherwise, no probe packets can
be sent out.
7. Configure optional
parameters.
See “ Configuring optional
parameters for an NQA test
group
”
Optional.
Configuring TCP tests
TCP tests of an NQA test group are used to test the TCP connection between the NQA client and a port
on the NQA server and the time for setting up a connection. The test result helps you understand the
availability and performance of the services provided by the port on the server.
Configuration prerequisites
TCP tests require cooperation between the NQA server and the NQA client. Before you start TCP tests,
configure a TCP listening service on the NQA server. For more information about the TCP listening
service configuration, see “ Configuring the NQA server .”
Configuring TCP tests
To configure TCP tests:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter NQA test group view.
nqa entry admin-name
operation-tag
N/A
3. Configure the test type as TCP
and enter test type view.
type tcp N/A
4. Configure the destination
address of TCP probe packets. destination ip ip-address
By default, no destination IP
address is configured.
The destination address must be
the same as the IP address of the
listening service configured on the
NQA server.
5. Configure the destination port
of TCP probe packets.
destination port port-number
By default, no destination port
number is configured.
The destination port number must
be the same as that of the listening
service on the NQA server.