H3C Technologies H3C SR8800 - Manual (Page 34)

22
Step Command Remarks
6. Configure the source IP
address of TCP probe packets. source ip ip-address
Optional.
By default, no source IP address is
specified.
The source IP address must be the
IP address of a local interface. The
local interface must be up;
otherwise, no probe packets can
be sent out.
7. Configure optional
parameters.
See “ Configuring optional
parameters for an NQA test
group
”
Optional.
Configuring UDP echo tests
UDP echo tests of an NQA test group are used to test the connectivity and round-trip time of a UDP packet
from the client to the specified UDP port on the NQA server.
Configuration prerequisites
UDP echo tests require cooperation between the NQA server and the NQA client. Before you start UDP
echo tests, configure a UDP listening service on the NQA server. For more information about the UDP
listening service configuration, see “
Configuring the NQA server .”
Configuring UDP echo tests
To configure UDP echo tests:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter NQA test group view.
nqa entry admin-name
operation-tag
N/A
3. Configure the test type as UDP
echo and enter test type view. type udp-echo N/A
4. Configure the destination
address of UDP packets.
destination ip ip-address
By default, no destination IP
address is configured.
The destination address must be
the same as the IP address of the
listening service configured on the
NQA server.
5. Configure the destination port
of UDP packets.
destination port port-number
By default, no destination port
number is configured.
The destination port number must
be the same as that of the listening
service on the NQA server.
6. Configure the size of the data
field in each UDP packet.
data-size size
Optional.
100 bytes by default.