H3C Technologies H3C SR8800 - Manual (Page 176)

164
Figure 57 Network diagram
Configuration procedure
# Configure interface GigabitEthernet 1/1/2.
system-view
[RouterA] ipv6
[RouterA] interface GigabitEthernet1/1/2
[RouterA-GigabitEthernet1/1/2] ip address 1.1.1.1 255.255.0.0
[RouterA-GigabitEthernet1/1/2] quit
# Configure a QoS policy to mirror traffic entering GigabitEthernet 1/1/1 to NetStream interface
2/0/1.
[RouterA] acl ipv6 number 2000
[RouterA-acl6-basic-2000] rule 1 permit source any
[RouterA-acl6-basic-2000] quit
[RouterA] traffic classifier ns_ipv6
[RouterA-classifier-ns_ipv6] if-match acl ipv6 2000
[RouterA-classifier-ns_ipv6] quit
[RouterA] traffic behavior ns_ipv6
[RouterA-behavior-ns_ipv6] mirror-to interface Net-Stream 2/0/1
[RouterA-behavior-ns_ipv6] quit
[RouterA] qos policy ns_ipv6
[RouterA-qospolicy-ns_ipv6] classifier ns_ipv6 behavior ns_ipv6
[RouterA-qospolicy-ns_ipv6] quit
# Configure interface GigabitEthernet 1/1/1, and apply the QoS policy to the inbound direction of
GigabitEthernet 1/1/1.
[RouterA] int GigabitEthernet1/1/1
[RouterA-GigabitEthernet1/1/1] ipv6 address 10::1/64
[RouterA-GigabitEthernet1/1/1] qos apply policy ns_ipv6 inbound
[RouterA-GigabitEthernet1/1/1] qos apply policy ns_ipv6 outbound
[RouterA-GigabitEthernet1/1/1] quit
# Enable IPv6 NetStream on Router A. Specify to export NetStream data to IP address 1.1.1.2 and port
5000 (the NetStream server), leaving the default for source address.
[RouterA] ipv6 netstream
[RouterA] ipv6 netstream export host 1.1.1.2 5000
1.1.1.2/16
Network
NetStream server
Router A
GE1/1/2
1.1.1.1/16
15::1/64