H3C Technologies H3C SR8800 - Manual (Page 152)

140
Before you configure NetStream, configure QoS first to identify the traffic matching the classification
criteria and configure a traffic behavior with the action of mirroring the identified traffic to a NetStream
interface of a NetStream-capable card (SPC card, SPE card, or NAM card). For more information about
class, traffic behavior, QoS policy, see ACL and QoS Configuration Guide.
To configure QoS-based NetStream:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable NetStream. ip netstream
By default, NetStream is
disabled.
3. Define a class and enter
its view. traffic classifier classifier-name [ operator
{ and | or } ]
N/A
4. Define a match criterion. if-match match-criteria N/A
5. Return to system view. quit N/A
6. Create a traffic behavior
and enter traffic behavior
view.
traffic behavior behavior-name N/A
7. Configure the action of
mirroring traffic to the
interface on a NetStream
card.
mirror-to interface Net-Stream
interface-number By default, no action of traffic
mirroring is configured.
8. Return to system view. quit N/A
9. Create a policy and enter
its view.
qos policy policy-name N/A
10. Specify a behavior for a
class in the policy. classifier classifier-name behavior
behavior-name
N/A
11. Return to system view. quit N/A
12. Enter interface view. interface interface-type interface-number N/A
13. Apply a QoS policy.
qos apply policy policy-name { inbound |
outbound }
N/A
Configuring NetStream on an SPC card
NOTE:
•
This feature is supported by SPC cards only.
• To enable NetStream on an interface of an SPC card, NetStream sampling is required.
To configure NetStream on an SPC card:
Step Command Remarks
1. Enter system
view.
system-view N/A