H3C Technologies H3C SR8800 - Manual (Page 193)

181
NOTE:
The trap buffer receives the trap information only, and discards the log and debugging information even
if you have configured to output them to the trap buffer.
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable information center. info-center enable
Optional.
Enabled by default.
3. Name the channel with a
specified channel number.
info-center channel
channel-number name
channel-name
Optional.
See
Table 7 for default channel
names.
4. Configure the channel through
which system information can
be output to the trap buffer and
specify the buffer size.
info-center trapbuffer [ channel
{ channel-number |
channel-name } | size buffersize ]
*
Optional.
By default, system information is
output to the trap buffer through
channel 3 (known as trapbuffer)
and the default buffer size is 256.
5. Configure the output rules of
the system information.
info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level
severity | state state } * | log { level
severity | state state } * | trap
{ level severity | state state } * ] *
Optional.
See “
Default output rules of system
information .”
6. Configure the format of the
time stamp. info-center timestamp { debugging
| log | trap } { boot | date | none }
Optional.
The time stamp format for log, trap
and debugging information is date
by default.
Outputting system information to the log buffer
NOTE:
You can configure to output log, trap, and debugging information to the log buffer, but the log buffer
receives the log and debugging information only, and discards the trap information.
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable information center. info-center enable
Optional.
Enabled by default.
3. Name the channel with a
specified channel number.
info-center channel
channel-number name
channel-name
Optional.
See
Table 7 for default channel
names.