H3C Technologies H3C S7500E Series Switches - Manual (Page 97)

3-15
To do… Use the command… Remarks
Enable global MPLS TE mpls te
Required
Disabled by default
Exit to system view quit ––
Enter the interface view of an
MPLS TE link
interface interface-type
interface-number
––
Enable interface MPLS TE mpls te
Required
Disabled by default
Exit to system view quit ––
Create a tunnel interface and enter
its view
interface tunnel tunnel-number Required
Assign an IP address to the tunnel
interface
ip address ip-address netmask Required
Set the tunnel protocol to MPLS
TE
tunnel-protocol mpls te Required
Configure the destination address
of the tunnel
destination ip-address Required
Configure the tunnel ID of the
tunnel
mpls te tunnel-id tunnel-id Required
Submit the current tunnel
configuration
mpls te commit Required
z
Depending on the MPLS TE signaling protocol a tunnel uses, the basic capabilities you
configured in this section may be inadequate for the tunnel to work and you may need to make
extra configurations.
z
For information about tunnel interfaces, see Tunneling Configuration in the Layer 3 - IP Services
Configuration Guide .
Creating MPLS TE Tunnel over Static CR-LSP
Creating MPLS TE tunnels over static CR-LSPs does not involve configuration of tunnel constraints or
the issue of IGP TE extension or CSPF. What you need to do is to create a static CR-LSP and a TE
tunnel using static signaling and then associate them.