H3C Technologies H3C S7500E Series Switches - Manual (Page 140)

3-58
[SwitchA-Tunnel1] tunnel-protocol mpls te
[SwitchA-Tunnel1] destination 2.2.2.2
[SwitchA-Tunnel1] mpls te signal-protocol rsvp-te
[SwitchA-Tunnel1] mpls te commit
[SwitchA-Tunnel1] return
4) Verify the configuration
# On Switch A, display the detailed information about the BFD session between Switch A and Switch
B.
display bfd session verbose
Total Session Num: 1 Init Mode: Active
Session Working Under Ctrl Mode:
Local Discr: 21 Remote Discr: 20
Source IP: 12.12.12.1 Destination IP: 12.12.12.2
Session State: Up Interface: Vlan-interface12
Min Trans Inter: 400ms Act Trans Inter: 400ms
Min Recv Inter: 400ms Act Detect Inter: 2000ms
Running Up for: 00:00:01 Auth mode: None
Connect Type: Direct Board Num: 6
Protocol: RSVP
Diag Info: No Diagnostic
CR-LSP Backup Configuration Example
Network requirements
Set up an MPLS TE tunnel from Switch A to Switch C. Use CR-LSP hot backup for it.
Figure 3-10 CR-LSP backup
Switch A
Loop0
Vlan-int1
Switch B Switch C
Switch D
Loop0 Loop0
Vlan-int1 Vlan-int2
Vlan-int2
Vlan-int4 Vlan-int3
Vlan-int4 Vlan-int3
Loop0
Device Interface IP address Device Interface IP address
Switch A Loop0 1.1.1.9/32 Switch D Loop0 4.4.4.9/32
Vlan-int1 10.1.1.1/24 Vlan-int4 30.1.1.2/24
Vlan-int4 30.1.1.1/24 Vlan-int3 40.1.1.1/24
Switch B Loop0 2.2.2.9/32 Switch C Loop0 3.3.3.9/32
Vlan-int1 10.1.1.2/24 Vlan-int2 20.1.1.2/24
Vlan-int2 20.1.1.1/24 Vlan-int3 40.1.1.2/24
Configuration procedure
1) Assign IP addresses and masks to interfaces (see Figure 3-10 )