H3C Technologies H3C S7500E Series Switches - Manual (Page 130)

3-48
[SwitchB] display mpls te tunnel
LSP-Id Destination In/Out-If Name
- - Vlan1/Vlan2 Tunnel0
[SwitchC] display mpls te tunnel
LSP-Id Destination In/Out-If Name
- - Vlan2/- Tunnel0
Perform the display mpls lsp command or the display mpls static-cr-lsp command on each switch
to verify information about the static CR-LSP.
[SwitchA] display mpls lsp
-------------------------------------------------------------------
LSP Information: STATIC CRLSP
-------------------------------------------------------------------
FEC In/Out Label In/Out IF Vrf Name
3.3.3.3/32 NULL/20 -/Vlan1
[SwitchB] display mpls lsp
------------------------------------------------------------------
LSP Information: STATIC CRLSP
------------------------------------------------------------------
FEC In/Out Label In/Out IF Vrf Name
-/- 20/30 Vlan1/Vlan2
[SwitchC] display mpls lsp
------------------------------------------------------------------
LSP Information: STATIC CRLSP
------------------------------------------------------------------
FEC In/Out Label In/Out IF Vrf Name
-/- 30/NULL Vlan1/-
[SwitchA] display mpls static-cr-lsp
total statics-cr-lsp : 1
Name FEC I/O Label I/O If State
Tunnel0 3.3.3.3/32 NULL/20 -/Vlan1 Up
[SwitchB] display mpls static-cr-lsp
total statics-cr-lsp : 1
Name FEC I/O Label I/O If State
Tunnel0 -/- 20/30 Vlan1/Vlan2 Up
[SwitchC] display mpls static-cr-lsp
total statics-cr-lsp : 1
Name FEC I/O Label I/O If State
Tunnel0 -/- 30/NULL Vlan2/- Up
On an MPLS TE tunnel configured using a static CR-LSP, traffic is forwarded directly based on label at
the transit nodes and egress node. Therefore, it is normal that the FEC field in the sample output is
empty on Switch B and Switch C.
7) Create a static route for routing MPLS TE tunnel traffic.
[SwitchA] ip route-static 3.2.1.2 24 tunnel 0 preference 1