H3C Technologies H3C S7500E Series Switches - Manual (Page 209)

5-17
Resetting BGP L2VPN Connections
To do… Use the command… Remarks
Reset BGP L2VPN connections
reset bgp l2vpn { as-number |
ip-address | all | external |
internal }
Available in user view
MPLS L2VPN Configuration Examples
Example for Configuring a Remote CCC Connection
Network requirements
z
The CEs are connected to the PEs through VLAN interfaces.
z
A remote CCC connection is created between CE 1 and CE 2.
The main steps for configuring a CCC remote connection are:
z
Create remote CCC connections on the PEs. No static LSP is required on the PEs.
z
Configure two static LSPs on the P device for packets to be transferred in both directions.
Figure 5-3 Network diagram for configuring a remote CCC connection
CE 1 CE 2
Remote CCC connection
PE 1 PE 2 P
Vlan-int30
Vlan-int30
Vlan-int20
Vlan-int20
Vlan-int10 Vlan-int10
Vlan-int10 Vlan-int10
Loop0 Loop0 Loop0
Device Interface IP address Device Interface IP address
CE 1 Vlan-int10 100.1.1.1/24 P Loop0 10.0.0.2/32
PE 1 Loop0 10.0.0.1/32 Vlan-int20 10.2.2.2/24
Vlan-int30 10.1.1.1/24 Vlan-int30 10.1.1.2/24
CE 2 Vlan-int10 100.1.1.2/24 PE 2 Loop0 10.0.0.3/32
Vlan-int20 10.2.2.1/24
Configuration procedure
1) Configure CE 1
system-view
[Sysname] sysname CE1
[CE1] interface vlan-interface 10
[CE1-Vlan-interface10] ip address 100.1.1.1 24
2) Configure PE 1
# Configure the LSR ID and enable MPLS globally.
system-view
[Sysname] sysname PE1
[PE1] interface loopback 0