H3C Technologies H3C S7500E Series Switches - Manual (Page 198)

5-6
Configuring MPLS L2VPN
You can select any of the implementation methods for MPLS L2VPN as needed. However, no matter
what method you select, you must complete these two tasks:
z
Configuring MPLS basic capability
z
Enabling MPLS L2VPN
Follow these steps to complete the above two tasks:
To do… Use the command… Remarks
Enter system view system-view —
Configure the LSR ID mpls lsr-id lsr-id Required
Configure MPLS basic capability
and enter MPLS view
mpls Required
Return to system view quit —
Specify the reserved VLAN mpls l2vpn reserve vlan vlan-id
Optional
Required when using
LSQ1SRP1CB engine.
Enable MPLS L2VPN mpls l2vpn Required
Configuring a PE Interface Connecting a CE
A PE interface connecting a CE can use these encapsulation types:
z
Ethernet
z
VLAN
Configuring a PE Interface Connecting a CE to Use Ethernet
z
An Ethernet interface can use the encapsulation type of Ethernet. For Ethernet interface
configuration information, see Ethernet Port Configuration in the Layer 2 - LAN Switching
Configuration Guide .
z
A VLAN interface using the link type of access can use the encapsulation type of Ethernet. For
configuration information about VLAN interface and link type, see VLAN Configuration in the
Layer 2 - LAN Switching Configuration Guide .
Configuring a PE Interface Connecting a CE to Use VLAN
A VLAN interface using the link type of trunk or hybrid can use the encapsulation type of VLAN (the
VLAN interface and the CE must reside in the same VLAN). For configuration information about VLAN
interface and link type, see VLAN Configuration in the Layer 2 - LAN Switching Configuration Guide.