H3C Technologies H3C S7500E Series Switches - Manual (Page 89)

3-7
path, traffic is switched to the new path and the previous path is torn down. This helps avoid traffic
interruption effectively.
RSVP-TE messages
RSVP-TE uses RSVP messages with extensions. The following are RSVP messages:
z
Path messages: transmitted along the path of data transmission downstream by each RSVP
sender to save path state information on each node along the path.
Resv messages: sent by each receiver upstream towards senders to request resource
reservation and to create and maintain reservation state on each node along the reverse of data
transmission path.
z
PathTear messages: sent downstream immediately once created to remove the path state and
related reservation state on each node along the path.
z
ResvTear messages: sent upstream immediately once created to remove the reservation state on
each node along the path.
z
PathErr messages: sent upstream to report Path message processing errors to senders. They do
not affect the state of the nodes along the path.
z
ResvErr messages: sent downstream to notify the downstream nodes that error occurs during
Resv message processing or reservation error occurs as the result of preemption.
z
ResvConf messages: sent to receivers to confirm Resv messages.
z
Hello messages: sent between any two directly connected RSVP neighbors to set up and
maintain the neighbor relationship that has local significance on the link.
The TE extension to RSVP adds new objects to the Path message and the Resv message. These
objects carry not only label bindings but also routing constraints, supporting CR-LSP and FRR.
z
New objects added to the Path message include LABEL_REQUEST, EXPLICIT_ROUTE,
RECORD_ROUTE, and SESSION_ATTRIBUTE.
z
New objects added to the Resv message include LABEL and RECORD_ROUTE
The LABEL_REQUEST object in the Path message requests the label bindings for an LSP. It is also
saved in the path state block. The node receiving LABEL_REQUEST advertises the label binding
using the LABEL object in the Resv message to the upstream node, thus accomplishing label
advertisement and transmission.
Setting up an LSP tunnel
Figure 3-2 shows how to set up a LSP tunnel with RSVP:
Figure 3-2 Set up an LSP tunnel
The following is a simplified procedure for setting up an LSP tunnel with RSVP:
1) The ingress LSR sends a Path message that carries the label request information, and then
forwards the message along the path calculated by CSPF hop-by-hop towards the egress LSR.
2) After receiving the Path message, the egress generates a Resv message carrying the reservation
information and label and then forwards the message towards the ingress along the reverse